Research Article
Effects of Shearing Rate on the Stress-strain Response and Shear Strength of Red Clay: A Case Study of Wolaita Sodo City, Ethiopia
Issue:
Volume 11, Issue 3, September 2026
Pages:
59-68
Received:
12 October 2026
Accepted:
26 October 2026
Published:
9 November 2026
Abstract: Rapid infrastructure development in Wolaita Sodo City, Ethiopia, relies extensively on locally available tropical red clay, whose high plasticity and compressibility result in complex mechanical behavior. However, the sensitivity of this residual soil to shearing rate under rapid and transient loading conditions remains poorly understood. This study investigates the effects of shearing rate on the stress-strain response, peak deviator stress, and shear strength of Wolaita Sodo red clay. Disturbed and undisturbed samples were collected from eight test pits distributed across four sub-cities at depths of 2.5-3.0 m. The experimental program included index-property characterization, Modified Proctor compaction, and Unconsolidated Undrained (UU) and Consolidated Undrained (CU) triaxial compression tests conducted at axial displacement rates of 0.01, 0.1, and 1.0 mm/min. The results demonstrate pronounced rate-dependent behavior. Increasing the displacement rate from 0.01 to 1.0 mm/min increased the peak deviator stress and undrained shear strength, while reducing the axial strain at failure, indicating a transition from more ductile to more brittle deformation. The CU tests also showed increases in the derived effective strength parameters, (c') and ϕ', with increasing shearing rate, although the magnitude of this response varied among test pits and confining pressures. Higher confining pressures generally increased the overall shear resistance. These findings provide site-specific experimental parameters for evaluating foundations, slopes, and other geotechnical structures constructed on tropical red clay deposits.
Abstract: Rapid infrastructure development in Wolaita Sodo City, Ethiopia, relies extensively on locally available tropical red clay, whose high plasticity and compressibility result in complex mechanical behavior. However, the sensitivity of this residual soil to shearing rate under rapid and transient loading conditions remains poorly understood. This stud...
Show More
Research Article
Predictive-Experimental Modeling of Biocementation (MICP) for the Reliability-Based Design of Shallow Foundations in Lima Silty Sands
Cleto Mauricio Vidal Lopez*
Issue:
Volume 11, Issue 3, September 2026
Pages:
69-74
Received:
16 July 2026
Accepted:
28 July 2026
Published:
16 November 2026
DOI:
10.11648/j.es.20261103.12
Downloads:
Views:
Abstract: Context: Urban expansion in Lima has forced the occupation of low-compaction aeolian deposits in high-vulnerability sectors like Lomo de Corvina and Villa El Salvador. Objective: This study develops and validates a predictive-experimental microbially induced calcite precipitation (MICP) model based on reliability engineering to quantify and reduce geotechnical uncertainty in shallow foundations. Methodology: Cylindrical specimens of aeolian sand were extracted and inoculated with Sporosarcina pasteurii (OD600: 0.8-1.2) and subjected to equimolar cementation cycles of urea and CaCl2 (0.5 M) every 12 hours. Geomechanical performance was evaluated through direct shear and load tests, and the mechanical variability was rigorously quantified via Monte Carlo simulations operating over 10,000 iterations to compute limit state functions under local building standards. Results: Biocementation promoted a fundamental transition toward a highly predictable geomechanical system (R2 =0985 for the biogenic cohesion-friction correlation and R2 = 0.992 for settlement control). The internal friction angle increased from 31.0° to 34.5° while inducing effective biogenic cohesion, resulting in a 304% increase in allowable bearing capacity (qadm), reaching up to 4.85 kg/cm2. Serviceability Limit State (SLS) design settlements stabilized tightly at 1.45 cm. Conclusions: The biochemical treatment elevates the structural reliability index (β) from a critical baseline of 2.1 to a high-safety target of 3.5. This mathematical enhancement drastically reduces operational failure probability below 0.01%, successfully complying with the stringent requirements of the E.030 and E.050 Peruvian Technical Standards.
Abstract: Context: Urban expansion in Lima has forced the occupation of low-compaction aeolian deposits in high-vulnerability sectors like Lomo de Corvina and Villa El Salvador. Objective: This study develops and validates a predictive-experimental microbially induced calcite precipitation (MICP) model based on reliability engineering to quantify and reduce ...
Show More